引用本文: | 陈玲,吴栋萁,杨涛,等.基于CIM的配电网模型到RTDS仿真模型的转换研究[J].电力系统保护与控制,2018,46(12):136-142.[点击复制] |
CHEN Ling,WU Dongqi,YANG Tao,et al.Model conversion from the CIM-based distribution network to RTDS[J].Power System Protection and Control,2018,46(12):136-142[点击复制] |
|
摘要: |
利用配网管理系统中基于CIM的配电网配置信息直接在RTDS中生成仿真模型,可以快速地构建配电网实时仿真模型并减少人为误差。在讨论CIM和RTDS模型的区别以及对应关系的基础上,分析了基于CIM的配电网模型转换到RTDS仿真模型的若干关键技术。在拓扑转换过程中提出了基于生成树的坐标位置生成法,在此基础上针对闭合环多且集中的拓扑电路提出了基于最小独立闭合环的方法,并用连枝比和分散度两个评价指标来判断适用于后者的电路拓扑。最后开发了相应模型转换软件,利用软件将一个真实的配电网转换到RTDS仿真系统中,从而进行了有效性验证。 |
关键词: 配电网 CIM RTDS 拓扑转换 生成树 最小独立闭合环 |
DOI:10.7667/PSPC170881 |
投稿时间:2017-06-13修订日期:2017-08-17 |
基金项目:国家重点研发计划项目资助(2016YFB0901300);国网浙江省电力公司科技项目(5211DS15002R) |
|
Model conversion from the CIM-based distribution network to RTDS |
CHEN Ling,WU Dongqi,YANG Tao,HUANG Xiaoming,WANG Linqing,XU Xidong |
(College of Electrical Engineering, Zhejiang University, Hangzhou 310027, China;State Grid Zhejiang Electric Power Research Institute, Hangzhou 310014, China;Hangzhou Pingdan Technology Company, Hangzhou 310000, China) |
Abstract: |
In order to quickly construct the real-time simulation model of the distribution network and reduce the human error, it is necessary to study the method of converting the CIM-based distribution network, which comes from DMS, into RTDS simulation model. After discussing the difference and relationship between CIM and RTDS model, a number of key technologies of automatic conversion from the CIM-based distribution network to RTDS simulation model are proposed. In the process of topology transformation, a method of generating coordinate position based on spanning tree is proposed. On this basis, a method based on minimum independent closed loop is proposed for closed loop and concentrated topology circuit. And two evaluated indicators, i.e. the connection branch ratio and dispersion, are used to determine the circuit topology that applies to the latter method. Finally, a software about corresponding model conversion is developed. And a real distribution network is converted to RTDS simulation system by the software, which verifies the effectiveness of the software. This work is supported by National Key Research and Development Program of China (No. 2016YFB0901300) and Technology Project of State Grid Zhejiang Electric Power Company (No. 5211DS15002R). |
Key words: distribution network CIM RTDS topology conversion spanning tree minimum independent closed loop |