引用本文: | 陈少华,桂存兵,雷 宇,马碧燕.基于小波包的永久性单相接地故障的故障选线的仿真研究[J].电力系统保护与控制,2007,35(1):18-20,25.[点击复制] |
CHEN Shao-hua,GUI Cun-bing,LEI Yu,MA Bi-yan.Simulation and research on permanent single-phase to ground fault based on wavelet packets[J].Power System Protection and Control,2007,35(1):18-20,25[点击复制] |
|
摘要: |
利用小波包的分频特性和重构算法,分别求取各线路中零序电流各频带能量,选出能量最大的频带为特征频带,对该频带的零序电流和系统零序电压通过模极大值和极性进行比较初步选定出可能故障的线路,然后在此基础上利用检测并联电阻投入瞬间在零序电流上所产生的二次奇异点最大值的方法来确定故障线路。仿真结果表明了该方法的有效性和正确性。 |
关键词: 小波包 故障选线 二次间断点检测 零序电流 最大值 |
DOI:10.7667/j.issn.1674-3415.2007.01.004 |
投稿时间:2006-07-25修订日期:2006-11-07 |
基金项目:广东省科技厅自然科学基金项目(040094) |
|
Simulation and research on permanent single-phase to ground fault based on wavelet packets |
CHEN Shao-hua,GUI Cun-bing,LEI Yu,MA Bi-yan |
(College of Automation,Guangdong University of Technology,Guangzhou 510090,China) |
Abstract: |
This paper calculates respectively energy of every band in zero sequence current of every line with frequency decomposition and signal reconstruction to select the band with the maximal energy as the feature band. At first, it selects all the “likely faulty” lines by comparing the maximal magnitude zero current and the corresponding polarity in all lines and the polarity of the zero sequence voltage’s first half wave, and then, by detecting maximum value of the second break point at the instant of the medium resistance is launched to select the fault line. Simulations indicate that this way is correct and effective. |
Key words: wavelet faulty line selection detecting of second break point zero sequence current maximum value |